How to Fix a Leaky Shower Head or Shower Faucet

A blabbermouthed, dripping showerhead is not entirely annoying, it wastes water. Before you call in a professional, this fairly common family trouble may be relatively simple to fix by yourself ( depending on the cause of the trouble ) .

How to Fix a Showerhead

Step 1: Turn Off Water

Shut off the water chief to the whole house. Have a towel handy — your body of water chief may be shut off, but there could hush be some urine left in the pipe that will come out .

Step 2: Remove and Inspect

Remove the showerhead by unscrewing it from the shriek with your hands. If the head is stuck on besotted ( as they often are if they have n’t been removed in a while ), use pliers or a crescent wrench to unscrew it. Look at the threads inside the showerhead for a small credit card washer or rubber O-ring. It ‘s much the break and tear of historic period on this component that can cause a showerhead to leak and start dripping. Over time, it dries out and becomes brittle which decreases its ability to hold in water. If it looks tire or damaged, replace it .

Helpful Tips

place a towel or big tease on the shower floor to protect it from possible damage if you happen to drop a joyride. besides cover the drain so that any of the modest parts from the showerhead do n’t incidentally go down it.

Remember not to force anything. Whether you ‘re taking off the showerhead or putting it bet on on, do n’t tighten it so tightly that you damage or crack something and then need to take on a larger visualize .

Step 3: Clean the Showerhead

Since you have the showerhead off, now is a estimable meter to clean out the showerhead, particularly if you ‘ve noticed decrease flow. Oftentimes, there can be mineral deposits or sediment left by hard water on the department of the interior of the showerhead or at the organ pipe stem turn ( where the shriek connects to the showerhead ). This can significantly affect urine pressure and menstruation and can contribute to a leaky showerhead .
In a small cook pot or pan, mix urine and three cups of vinegar and bring it to a boil. Once it ‘s started to boil, turn off the heat. Place the showerhead ( minus any rubber parts that can be removed ) into the solution and let it sit for approximately 20 to 30 minutes. then remove, rinse and scrub the inside and outdoor jets with an old toothbrush ; do this until no deposits remain .

Step 4: Tape It Up

If the washer or O-ring looks okay or you ‘ve replaced it, the following step is to wrap the threads on the pipe stem with Teflon record. Do n’t overdo it with magnetic tape though. Wrap a thin strip around the threads at the very tip of the pipe stem turn .

Step 5: Reattach the Showerhead

Screw the showerhead binding on by hand-tightening it until you ca n’t turn it anymore. then use pliers to give it a final examination turn. Remember not to turn besides hard or you could break the showerhead or pipe .

Step 6: Turn On the Water

Turn the water back on and then run your lavish for a few seconds. Turn it off. Wait a few minutes and then check to see if there still is a drip or leak .

How to Fix a Shower Faucet

If you ‘ve fixed the showerhead and a leak persists, you may have a escape in the shower faucet. normally, this is from a exhausted washer on the exhibitor stem, which can well be replaced. You do n’t need to call a plumber. Follow these steps to do it yourself .

Step 1: Cut Off Water

As you did with the showerhead, you will need to cut off the water provision to the shower at the water system main. future, open the faucet and let water drain out. Keep a towel on bridge player to soak up body of water that may be released from the pipes once you remove the faucet .

Safety Alert!

Because you will be standing in the tub or exhibitor to do this project, be certain that the floor coat is dry. Any moisture could cause you to slip and fall .

Step 2: Take the Faucet Apart

How you disassemble it depends on what kind of faucet you have : one-knob or two-knob style. If you have a two-knob system then you will need to replace both valves. Use a screwdriver and crescent wrench to unscrew the valves and remove the shower faucet knob or handles. Remove the guard and set it aside. You should see two nuts. Unscrew the larger of the two ; alone one of them needs to be unscrewed to reach the shower stem turn. Remove the shower root by unscrewing it in a counterclockwise direction.

Step 3: Replace Washers

The shower stem works with several washers. You should replace all of them while you ‘ve got the faucet disassembled to make certain you cover all your bases, careless of their condition. Look for a rubber washer at the fag end of the stem. This is called the seat washer. The rest of them — packing washers — are at the center of the stem .

Step 4: Put the Faucet Back Together

Clean the pipes with an previous toothbrush and a cup of vinegar and water solution. Scrub away any mineral deposits you can see on the pipes. Reattach the shower root. Screw in the valves and reattach the node. After you ‘ve reattached the faucet faceplate or escutcheons, seal where they touch the shower wall by applying caulk around the integral denture .

How to Replace a Shower Faucet

If neither fixing the showerhead nor the faucet has dried up the drip, it may be fourth dimension to swap your honest-to-god faucet for a new one. While this project may be more involved, sometimes it is the only way to cure an ailing shower. Often this is a job for a accredited plumber, but it ‘s not impossible for a layman. While different faucets require unlike methods of surrogate, downstairs is a general template for the most common faucets .

Step 1: Find a Replacement

Shower faucets come in many styles and sizes. not all are interchangeable, so you need to find the correct substitute. note that there are general guidelines ( outlined in this stick out ), but it is important to follow the manufacturer ‘s instructions to be certain everything is connected correctly. Get an demand measurement of the holes for the faucet and take the old one with you to find the correctly substitute .

Step 2: Remove the Old Faucet

many homes have an access panel on the wall opposite the shower faucet so one can get in and work on the inner workings of the tub. If yours does n’t, you will have to cut into the opposition wall to access and remove the old faucet and install the raw one. Use a keyhole see to cut an approximately 12 ” square or orthogonal hole into the wall directly opposite the faucet .
Remove the base of the faucet using a organ pipe twist to unscrew the nuts fastening it to the shower regular. Be sure the faucet has been removed wholly from the water pipes. Do n’t twist or turn the pipes when you ‘re extracting the old faucet to avoid potential complications .

Helpful Tip

If the pipes in your home are previous, there could be complications from corrode pipes that can move around easily when you ‘re trying to remove the faucet. If this is the lawsuit, be careful so that you do not break the pipes which will cause water escape behind walls and frankincense, a more expensive and time-consuming visualize .

Step 3: Install New Faucet

When putting in the newfangled faucet fabrication, you will be lining it up with the shower organ pipe and fastening it to the pipe with the pipe wring. It is advised that you rigorously follow the instructions from the manufacturer on how to correctly hook the raw faucet up .

Step 4: Turn Water Back On

Turn the water back on at the main and check for any leaks. If you do notice any, try tightening nuts and screws to make certain everything is compressed and secure. The manufacturer ‘s instructions can guide you. If you ‘ve tightened every connection and there are still leaks, disconnect the faucet and startle over to make certain everything is done correctly.

Step 5: Patch the Wall

If you do n’t have the access panel discussed in footprint 2, now you ‘ve got a fairly bombastic fix in the wall inverse your shower. Do n’t fret, making a wall plot and then repainting the wall will make it look like the exercise was never done .
good work ! No matter which fix it took, you ‘ll no long hear that irritating drip, drip, drip .

Project Shopping List

here ’ s what you ’ ll need to complete this project successfully .

Related Posts

Leave a Reply

Your email address will not be published.